Whitfield Renaissance Pellet Stove Parts

Many of the parts for the Whitfield Renaissance pellet stove are no longer in production. Lennox purchased Whitfield many years ago and are slowly phasing these older models out. Below is the complete list of parts still available for the Renaissance model. If you have questions or need help finding your pellet stove parts please email us at info@a1stoves.com or call M-F, 8-5 pacific, 800-893-4950.

Whitfield Renaissance Pellet Stove Parts List (WW1)

Serial Numbers 1001-3607 Serial Numbers 3608 and UP
Model Years: 1990-1994

Electrical and Auger Components
13057801 Disc, High Limit (250 Deg.)
12046300 Motor, Auger (Drives pellet feed auger)
13656003 Hose, Pressure Switch, 19 in. (may need to be cut to size)
13025903 Pressure Switch Replacement
16050205 Thermostat, Wall, Honeywell (Wire, 16020204, not included)
12055908 Fuse, 6 Amp (Ser. Nos.3608-Up)
61050003 Gasket, Auger End Plate (Neoprene)
12045901 Control Cable

Burnpot and Firebrick Components
13046500 Firebrick Kit
13053500 Grate, WW1-WP3-I

6 thoughts on “Whitfield Renaissance Pellet Stove Parts

  1. Colleen Morgan

    Hello…..I’m looking for a door ( glass door) for the WWI Whitfield Renaissance pellet stove …serial number 03194. The glass broke in the door. I have a replacement glass…but while removing the broken glass a corner broke where one of the screws is that holds the small metal piece that holds the glass in place. My stove is Ivory in color. Is there any hope of finding a replacement glass door? Or, do you know if I can drill a new hole to hold the metal piece that holds the glass in place?
    Thank you for any help.
    Colleen

  2. sootysue Post author

    Hi Colleen,

    Thanks for contacting us. I’m afraid the door for your Renaissance pellet stove has been out of production for a number of years. These body parts are hard to come by, your best bet will be to watch eBay or local ads for a used door from a Renaissance. The paint can be matched up so no need to fret about color. I believe the Whitfield ivory is called “Sand”.

    Hope this helps and good luck with your search!

  3. Murphy's Chimney & Fireplace

    Need manuel for Renaissance WWI, ser # 01543. We may need a controll board

  4. bart

    how to clean control board thier is not much defrence in fan speed when set from 1to 5 and what else could be causing that

  5. sootysue Post author

    Hello,

    Thank you for contacting us on our blog. I’ve emailed you the manual for the Whitfield Renaissance to this email, please see the troubleshooting section on page 30. If you have adjusted the speed on the control board, it may be time to call a service tech to determine if the board is bad. You don’t want to “clean” the board in any way other than to blow off any soot or dust. The boards can be very sensitive and are not cheap to replace. If your service tech deems the control board is bad, we sell the new boards for $576:
    http://a1stoves.com/whitfield-renaissance-control-board-p-23391.html

    We also offer a control board repair service for $225:
    http://a1stoves.com/control-board-repair-service-p-17044.html

    Please let us know if you have any other questions and thanks again for contacting us.

Leave a Reply